HCJ6-XXX

IEC61850 Protocol Converter

Configure as needed. 1 61850   protocol converter can communicate with PM6-M or directly with multiple   sub-monitors

PM6-M

Master monitor

10-inch touch screen, when not   equipped with the main monitor, the sub-monitors also support uploading   information separately

PM6-ACM

AC sub-monitor

7-inch touch screen, to be   configured when AC switching is involved, to be configured when an   independent AC monitor or AC topology diagram is required

PM6-DCM

DC sub-monitor

7-inch touch screen. 1 DCM per   battery group, but 3 DCMs are needed for 3 charges and 2 charges (backup   charger)

PM6-JCM

Feeder monitor

7-inch touch screen. One PM6-JCM   can monitor two DC feeders, which must be configured when the loop closing   function needs to be detected.

PM6-JCM-J

Feeder split screen monitor

7-inch touch screen. One PM6-JCM   can understrap up to 16 PM6-JCM-J

PM6-TCM

UPS/Communication Power Monitor

7-inch touch screen. Can be used   as a special monitor for independent UPS cabinet/communication power cabinet

PM6S

Monitor

7-inch touch screen. Cooperate   with the PM6US unit to realize a low-cost single-charge and single-charge   monitoring solution.

PS6-P1

Monitor

The 4.3-inch touch screen,   combined with PS6-S1, realizes a low-cost single-charge and single-charge   monitoring solution.

PS6-P2

Monitor

The 7-inch touch screen, combined   with PS6-S1, realizes a low-cost single-charge and single-charge monitoring   solution.

PM6A

AC Monitoring Unit

Detect two three-phase AC voltage   and current, and realize 3-in-2 AC switching

PM6D

DC Monitoring Unit

Detect bus voltage, battery   voltage, bus-to-ground voltage, battery current and bus control current

PM6K-64

Switch monitoring unit

64 measuring points, switch fault,   switch status, leakage current, and current detection in one

PM6K-32

Switch monitoring unit

32 measuring points, switch fault,   switch status, leakage current and current detection are integrated

PM6B-12V

Battery inspection unit

12V, 24 knots

PM6B-2V

Battery inspection unit

2V, 56 knots

PM6JH

Integrated monitoring unit

Detect DC voltage of two-section   DC bus

PM6C

Switch control unit

24 output dry contacts/12 electric   control units

PM6US

Integrated monitoring unit

Detect two single-phase or   three-phase AC voltage and contactor status, and control two AC contactors

BST1-U

Internal resistance concentrating   unit

Can downband up to 128 internal   resistance acquisition units

BST1-2V

Internal resistance acquisition   unit

Collect the voltage, internal   resistance and temperature of 2V single cell

BST1-12V

Internal resistance acquisition   unit

Collect the voltage, internal   resistance and temperature of 2V single cell